Complete The Finished Wall; Clean-Up After Installation - Kohler K-1106 Guia De Instalacion

Ocultar thumbs Ver también para K-1106:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

11. Complete the Finished Wall

If you have not already done so, carefully remove the protective tape from the whirlpool rim.
Cover the framing with water-resistant wall material.
Tape and mud the water-resistant wall material. Install the finished wall to the water-resistant wall
material.
Seal the joints between the whirlpool rim and the finished wall material with silicone sealant.
Install the faucet trim according to the instructions packed with the trim.

12. Clean-Up After Installation

When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the
whirlpool surface. Use warm water and a liquid detergent to clean the surface.
Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners
containing petroleum distillates to remain in contact with any whirlpool surfaces for long periods
of time. Remove plaster by carefully scraping with a wood edge. Do not use metal scrapers, wire
brushes, or other metal tools. Use a powder-type detergent on a damp cloth to provide mild
abrasive action to any residual plaster.
Kohler Co.
Apply silicone sealant to the
Finished Deck
edges of the water-resistant
Material
deck material and the
finished deck.
Whirlpool
Drop-In Installation
Water-Resistant
Deck Material
Framing Material
13
1055820-2-C

Publicidad

Tabla de contenido
loading

Tabla de contenido