ROMPA Manhattan II Manual Del Usuario página 11

8 COLOUR WIREFREE CONTROLLER
1. This switch is supplied plugged into the socket inside the Manhattan so that it is on
charge whilst the Manhattan is plugged into the mains and switched on.
2. The switch can be unplugged for wireless use of this switch.
3. Make sure that you plug this switch back into its socket after use to maintain its
charge. You may wish to label this cable so that you can identify it should it ever
become separated from the Manhattan unit. The USB cable has the following
symbol on it:
4. Use this switch to select the colour of the bubble tube and light source for the fibre
optics. The switch is supplied in the 'All Wi Fi products' setting, meaning that the
colour of bubble tube and light source can be controlled at the same time. The
setting can be changed to control the colour of just the bubble tube or just the light
source. The 8 Colour Wirefree Controller is not compatible with the projector
supplied.
Please refer to the separate instructions required for the 8 Colour Wirefree Controller
LIGHT SOURCE AND FIBRE OPTICS
1. The fibre optics are supplied already secured inside the front of the light source. The
light source is inside the Manhattan. Do not pull on the fibre optics. Handle fibre
optics with care – do not bend them as the light will not pass beyond the bend of the
fibres. Make sure the fibres are curled around the bubble tube (as shown) and not
trailing on the floor when the Manhattan is moved. If they get caught under the
castors or trodden on they will become damaged.
The fibre optics supplied are 2m long (some of this will be fixed inside the unit) and have
100 strands.
Please refer to the separate instructions required for the Light Source and Fibre Optics