Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5. Loosely assemble head support to REESE
Slider at desired height.
NOTE: Bottom position may not be used on all
hitch models. Use the cotter pin(4) and indicator pin(6) to trap handle(3) in
place as shown. Be sure pin is installed in handle as shown. Install so that
the indicator pin goes through the bottom side of the latch casting and is in the
slot of the casting. (See Figure 11).
6. Snug up all bolts and nuts.
Torque 1/2" bolts to 85 ft. lb.
7. Coat top surface of slide tube and roller holes in each
slider assembly with all purpose grease or Teflon lube, use
as needed (see Figure 12). Repeat this application monthly
during use.
ROLLER
WELD ON FOOT
Slide hitches that are not properly locked can suddenly move and kill you!
•Never place any part of your body in the truck bed or between the truck and the trailer
unless each and every one of the following conditions are met :
1. Truck is in park with emergency brake on, and
2. All trailer wheels are blocked on each side of wheel.
•Always perform "push test" or "pull test" by following the instructions in this manual.
50024N Ŕ 7/5/11 F PCN12170
™
FIFTH Wheel
Cotter pin (4)
On back side
Figure 11
Indicator pin (6) below latch casting.
LEAF SPRING
LATCH
SLIDE TUBE
BOLT ON FOOT
To avoid death or serious injury:
©2011 CEQUENT PERFORMANCE PRODUCTS, INC.
Cotter pin (4).
On back inside.
LOCK WASHER
& BOLT
END CAP
WARNING:
Indicator pin (6)
ROLLERS
Figure 12
Figure 13
Printed in XXX
Figure 10
SLIDE TUBE
5
Publicidad
Tabla de contenido
