BOND MANUFACTURING HYPH4601-10 Manual Del Usuario página 4

PRECAUTIONS
· Installation and services should only be
made by a qualified person.
· Do not use the heater in an exposive
atmosphere.
· Before operation,inspect the hose for
damage.
·Disconnect LPG cylinder before moving the
heater.
·Do not attempt to alter any parts of heater.
Example:Using the heater without reflector or
protection guard.
· The appliance shall not be used in
basements or below ground level.
·It must always be placed on a solid and level
surface.
·Never substitute the regulator.Use only one
that is suitable for both appliance category and
normal pressure of gas.
·Do not clean the heater with cleaners that
are combustible or corrosive.
·Do not paint protection guard,control box or
reflector.
· The LPG gas cylinder valve should be
turned off when the heater is not in use.
·Do not use the heater when it is raining,and
do not let any liquid splash on to the glass tube
when the heater is in use.
·Keep children away from the heater,always
be careful not to knock over the heater which
will break the glass tube and might cause
injury.
· Do not move the appliance when in
operation.
·After a long break in operation,the gas parts
in the control box of the heater and the hose
should be inspected for spiders, spider webs or
other insects.
·Check the heater immediately if any of the
following exists:
1.There is smell of gas.
2.The heater is not effective enough.
3.The burner makes popping noise during
use(a slight popping noise is normal when the
burner is extinguished after use).
·The hose with regulator assembly should be
stored in a safe place to avoid accidental
damage.
·Children and adults should be aware of the
high surface temperature hazard,and should
keep a safe distance away to avoid clothes
burni ng or igniting.
·Young children should be carefully supervised
when they are in the working area of the heater.
·Clothing or other flammable material should
not be hung from the heater,or placed on or
near the heater.
· Do not obstruct the flow of combustion
products.
·Keep the ventilation opening of the cylinder
enclosure free and clear of debris.
·Do not obstruct the ventilation holes of the
cylinder housing.
·Shut off the valve to the gas cylinder or the
regulator before moving the appliance.
· The tubing or the flexible hose must be
changed within the prescribed intervals.
· Use only the type of gas and the type of
cylinder specified by the manufacturer.
· In case of violent wind,particular attention
must be taken against tilting or falling over of the
appliance.The manufacturer is not responsible
for any damage caused by bad weather.
APPLIANCE STAND AND LOCATION
sides 24 in /60.9 cm.
24 in /60.9cm
4
24 in /60.9 cm and
24 in /60.9cm
24 po /60.9