Kenmore 116.33725 Manual Del Propietário página 8

Ocultar thumbs Ver también para 116.33725:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SOME
MODELS
Bare floor setting: Slide the carpet/bare
floor selector
all the way back and down
toward the bottom of the nozzle until it locks
into place.
in this position the brush assembly
does not
revolve.
This setting should be used
for
cleaning hardwood
and tile floors and when
any attachments
(tools)
are used,
Carpet setting:
Slide the selector
all the
way forward
and up to the carpetposition.
In this position the brush assembly
will turn.
When carpets are being cleaned the selec-
tor should be in this position.
Attention:
Refer to your carpet manufac-
turers cleaning recommendations.
Some
more delicate carpets may require that they
be vacuumed
with the agitator turned off, to
prevent carpet damage.
!
'I? CAUTION
Do not allow vacuum cleaner to
remain in one spot for any length of
time when the agitator is turning.
Damage to carpet may occur.
NOTE:
For longer belt life, turn vacuum off
before moving selector.
Failure to do so can
cause the belt to rub on the selector shaft
and may result in the belt becoming
hot and
creating a burning rubber smell.
Carpet/Bare
Floor Selector
To Bare Floor
Position
_
To Carpet
Position
Release the handle by placing your foot on
the foot rest and pull back on the handle
until it releases from its upright position.
\
Foot Rest For
Handle
SOME MODELS
Release the handle by pressing down on
the handle release pedal with your foot and
pulling back and down on the handle with
your hand.
Handle
Release Pedal
To start the vacuum cleaner, step on the
ON/OFF switch located on the back of the
vacuum.
To stop the vacuum cleaner, step
on the switch a second time.
On/Off
8

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

116.33726

Tabla de contenido