Troubleshooting; Warranty Conditions - Thulos KOOL BREEZE TH-KB13 Manual De Instrucciones

TROUBLESHOOTING

Do not repair or disassemble the unit by yourself, unauthorized repair attempts will invalidate the
warranty and may cause bodily harm.
Issue
No power
No dust elimination
Odour emission from
unit
If the above solutions do not resolve the problem please contact the service centre.
ENVIRONMENT
This appliance should not be put into the domestic garbage at the end of its durability,
but must be offered at a central point for the recycling of electric and electronic
domestic appliances. This symbol on the appliance, instruction manual and packaging
puts your attention to this important issue. The materials used in this appliance can be
recycled. By recycling of used domestic appliances, you contribute an important push to the
protection of our environment. Ask your local authorities for information regarding the point of
recollection.

WARRANTY CONDITIONS

1. This appliance is covered against any factory defects.
2. The device is changed for a new one as long as it is within the change period and is returned
with all accessories and packaging in good condition.
3. The guarantee will be valid as long as the appliance is accompanied by your invoice or
purchase ticket where the exact device and model, or your warranty card duly completed
and sealed, is reflected.
Possible Reason
5. Power cord is not plugged in
6. No power from the socket.
7. Honeycomb filter support is not
installed correctly
8. The power button has not been
pressed.
3. The honeycomb filter is blocked.
4. The air inlet is blocked
3. New unit. When the unit is used for
the first time, the Honeycomb
cooling media will have an odour,
which will dissipate within a week of
use
4. Honeycomb filter
developed mould or bacterial growth
Solution
5. Connect the power cord
6. Check socket is switched on
– test with a different
appliance.
7. Install the honeycomb filter
correctly.
8. Press the power button
3. Remove the honeycomb
filter and clean it.
4. Remove the obstruction
1. No action required
2. Clean the filter pads with
mild antibacterial solution.
Dry before use.
may have