Maintenance - Truper TPN-883 Instructivo

Cylinder
• Remove the cylinder cover using the wrench (A).
• Remove the cylinder piston (B) using a wrench.
• Clean the inside, the piston shaft (C) and the ring (D).
• Add grease into the inner wall of the cylinder and ring.
• Fill the orifice where the piston shaft is inserted (E). Use
lubricating oil SAE-30 up to the washer first level. Set the
piston back in place and close the cover. Tighten firmly using
the wrench.
Riveter Chucks
• To carry out maintenance in the riveter chucks you need
to remove them with the wrenches (A), then, disassemble
the head parts (B).
• Clean all the pieces and apply lubric.
• Assemble back the chuck. Using the wrench with
adjusting limits to assure the head length is adequate.
TPN-883: 2 / " and TPN-884: 3
13
16
riveter performance may be deficient..
8
ENGLISH
B
C
E
/ " (C). Otherwise, the
5
16

Maintenance

A
D
A
B
C