Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1 - Presentation
The PoE SW4 can supply power, via the Ethernet RJ45 link, to the TYCAM 1100
INDOOR and TYCAM 2100 OUTDOOR cameras or any PoE (Power over Ethernet)
device (4 max.) compatible with standards PoE 802.3af and PoE 802.3at.
The power supply and data can transit simultaneously by ports 1, 2, 3 and 4.
The maximum power: for all 4 outputs is 58 W.
The PoE SW4 supports the Extend mode. The data transmission distance can reach
250 metres with the extended mode and a category 6 Ethernet cable.
This is a plug & play device and requires no special configuration.
2 - Package contents
1- PoE SW4
2- 230 V power supply adaptors.
3- Screws and plugs
4- Anti-slip pads
3
4
2
12
1
EU
UK
3 - Description
1
3
4
LINK/ACT
POE STATUS
PWR
OFF
ON
PoE MAX
EXTEND
1
7
2
3.1 Front panel:
LED
Status
Description
On steady
The device is properly connected to the mains power.
1 - PWR
Off
The device is poorly connected or not connected to the
mains power.
2- PoE-MAX
On steady
The PoE power reaches its lower limit value (6 W).
Flashing
The PoE power reaches its maximum (58 W).
Off
The PoE power supply operates correctly and the PoE
power available is greater than 6 W.
3- LINK-ACT
On steady
The corresponding port is correctly connected.
Flashing
Transmission or reception of data on the port
Off
The corresponding port is not properly connected or is not
connected.
4- PoE status
On steady
The corresponding port is connected and correctly supplies
power to the PoE peripheral device.
Flashing
The PoE output of the corresponding port exceeds 30 W.
Off
No POE compatible peripheral is connected.
5 - PoE ports - 1, 2, 3, 4.
6- Port 5 (UPLINK) Box ADSL
7- Extended mode selector. Refer to § 6.4.
3.2 Rear panel
8- Earth connection:
Connection of the PoE SW4 unit to the earth
connection.
9- Power outlet:
Use the 230 V power supply adapter supplied.
3
LINK/ACT
N/A
2
3
4
5
POE
UPLINK
5
6
8
9
51V
EN
13
Publicidad
Tabla de contenido
