Product Description - Urmet 1033/016 Manual De Instrucciones

ENGLISH

PRODUCT DESCRIPTION

• Excludable self-protection system composed of an Antimask on the
IR lens by active infrared.
• 2 sensitivity settings optimized for Inside, Outside in combination
with the trimmer for the adjustment of the coverage.
• Barrier: 8 m x 140 cm.
• Alarm memory, Antimask memory, and interactive management of
Led OFF.
• Ability to wall / wall installation or ceiling / floor installation using the
90° bracket and the swivel bracket (optional).
• Polycarbonate case IP61 resistant to atmospheric agents. Note: to
obtain IP61 apply the silicone to seal the cable entry.
• Deep optical slot for a high immunity of the infrared section to all of
the phenomena / disorders that do not show up in its field of
detection view.
• Filter LED to enable the vision of the detection only close to the
detector.
INSTALLATION
Open the detector by unscrewing the closing
screw.
Remove the circuit board by unscrewing the card
screw.
With 90° bracket (ref. 1033/018)
Cut the Locations A and B on the plastic bottom.
Cut the pre drilled cable entry in a suitable size to
the cable used. Pass the cable through the cable
entry hole and, for IP61, seal it with silicone. For
direct mounting to the wall, fix the plastic bottom
with the screws through the locations A and B. For
installation with 90° Bracket *, attach first the
bracket to the wall with the screws and then attach
the plastic bottom to the bracket through locations A
and B with the bracket screws.
Screw the circuit board to the plastic bottom.
Proceed with the cable connection.
*The 90° bracket can be mounted either left or
right handed.
DS1033-136B
Ref.1033/016
DUAL-TECHNOLOGY
DETECTOR FOR
OUTDOOR
CURTAIN COVERAGE
5