Avoid the following situations due to the risk of electric shock:
The electric parts must not come into contact with water or other
liquids. Never use the product if it is wet or damp.
Never attach safety pins or the like to the product.
The foot warmer must only be connected to installations
corresponding to the labelling found on the product.
Do not used if wet.
Shoes must be removed before use.
The foot warmer must always remain under observation when
plugged in, and it must be completely cooled before being stored away.
Always check the product for damage before use. Discard the product
if it shows signs of malfunctioning or damage.
Do not use it near open fire.
Long-term use at the highest heat level can result in burns.
Remove the foot warmer's plug from the power outlet after use, in
case of a malfunction, or when cleaning.
May not be used for animals.
If the power cord is damaged, it must be replaced by a specialized
technical service.
OPERATION
Control selections:
0 = OFF
1 = low heat
2 = medium heat
3 = high heat
It takes approximately 15 minutes to reach the desired temperature.
Remember that a temperature that the hand feels warm on may be
extremely hot for the feet.
There is an odour when you first time to use the foot warmer which is
normal. This odour is completely harmless, but be sure to air the foot
warmer after it has been used for the first time.
Begin by heating the foot warmer to the highest heat level. After 15
minutes the temperature can be adjusted to the desired level.