Important Safety Instructions - HAMPTON BAY 383-586 Manual De Instrucciones

Thank you for purchasing this Hampton Bay interior track pendant. This product has been manufactured with the highest standards of
safety and quality.
FEATURES:
1. Track pendant can be installed any locations into the track section(Sold separately).
2. Track Pendant is adjustable in length and comes complete with a Do-It-Yourself Pendant Adapter and wire; the wire can be cut to
desired lengths for different applications and ceiling heights.
3. Included clear dish glass shade and GU10 shielded bulb. (Non comprise)
QUESTIONS, PROBLEMS, MISSING PARTS:
Before returning to your local Home Depot, please call our Customer Service Team at 1-877-527-0313 or visit www.homedepot.com.
Please reference SKU383-586,UPC008938207829.
GENERAL
All electrical connections must be in accordance with local codes, ordinances or national electrical codes. If you are unfamiliar with
methods of installing electrical wiring, secure the services of a qualified electrician. Before starting installation, disconnect the power by
turning off the circuit breaker or removing the fuse at fuse box. Turning the power off using the light switch is not sufficient to prevent
electrical shock.
Note: The important safeguards and instructions appearing in this manual are not meant to cover all possible conditions and situations
that may occur. It must be understood that common sense, caution and care are factors that cannot be built into any product. These factors
must be supplied by the person(s) caring for, installing and operating the fixture. If at any time you are uncomfortable or are unsure of
what to do, please contact a qualified licensed electrician for further assistance.

IMPORTANT SAFETY INSTRUCTIONS

1. Read all instructions.
2. Do not install this lighting system in a damp or wet location.
3. Before energizing make sure that the lighting system is clear of all material which could cause a direct short and check all electrical
connections to make sure they are tight.
4. Do not install any part of this system (TRACK) less than 7 feet (2.2m) above floor.
5. To reduce the risk of fire and burns, do not install this lighting system where non insulated open bus-bar conductors can be shorted or
contact any conductive metals.
6. To reduce the risk of fire and overheating, make sure all connections are tight.
7. Turn off electrical power before modifying the light system in anyway.
8. For installation with HAMPTON BAY EC series track only.
9. CAUTION – To reduce the risk of a burn during re-lamping, remove from the track before re-lamping
10. Do not install any luminaire assembly closer than 6 inches from any curtain, or similar combustible material.
11. DANGER – RISK OF SHOCK – DISCONNECT POWER BEFORE INSTALLATION.
12. Do not touch lamp at any time. Turn off power and allow bulbs to cool down before replacing. Use a soft cloth, gloves, or re-lamping
tool (see diagram) to change bulbs. Oil from skin may damage the bulb.
13. CAUTION: LIGHTED LAMP IS HOT! Keep away from curtains and other combustible materials.
14. Do not touch hot lens, guard or enclosure.
TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION (not included):
Ladder Safety goggles
Electrical tape
PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):
x1 canopy
SAVE THESE INSTRUCTIONS
Wire stripper
x1 Pendant Fixtures x1 Hardware Packet
Gloves Flathead screwdriver
Box
x1 GU10 Bulb
2
.
Phillips screwdriver
x1 Bulb re-lamping tool