Mounting The Unit - Tru-Test PATRIOT PBX50 Manual Del Usario

This symbol on the product or its packaging
indicates that this product must not be
disposed of with other waste. Instead, it is
your responsibility to dispose of your waste
equipment by handing it over to a
designated collection point for the recycling
of waste electrical and electronic
equipment. The separate collection and
recycling of your waste equipment at the
time of disposal will help conserve natural
resources and ensure that it is recycled in a
manner that protects human health and the
environment. For more information about
where you can drop off your waste
equipment for recycling, please contact
your local city recycling office or the dealer
from whom you purchased the product.
Units marked with this symbol are time
delayed electric fence units with a delay
time of 50 seconds.
Installation
1 Connect the Fence ground terminal to a
separate ground system that is at least 33'
(10 m) away from other ground systems.
2 Connect the Fence output terminal to the
fence.
3 Connect the unit to a 12 V battery using
the battery leads. Attach the + (red) clip to
the positive terminal of the battery, and the
– (black) clip to its negative terminal.
4 To prevent damage caused by stock
interference and bad weather, house the
battery and the unit in protective
enclosures.
2

Mounting the unit

The unit can be mounted directly onto a steel T-
post or Y-post using the mounting slot in the
case rear.
Back of the
unit
Alternatively, the unit can be mounted onto a
wooden post, another suitable vertical support
or suitable wall material using the two 3‛
(75 mm) nails and two washers provided. Thread
washers onto the nails. Space the nails 3‛
(75 mm) apart (or one nail length). Hammer in
the nails, allowing them to protrude by 3/8‛
(10 mm). Slide the unit onto the nails with the
washers inside the mounting slot.
Note:
If the unit is being mounted on a wall
made of concrete, brick, plasterboard or similar,
use screws instead of nails. Wall anchors or
plugs may also be required.
Mounting slot