Safety Information - Portfolio VEL-8041MD-BN Instrucciones De Ensamblaje

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install the product.
CAUTION
Turn off the main power at circuit breaker before installing fixture.
●
There is no serviceable part inside the motion sensor. Do not try to repair or disassemble the unit. Doing so could
●
damage the unit and cause possible electrical shock. Consult a qualified electrician if needed.
Save these instructions.
●
WARNING
All electrical connections must be in accordance with local and National Electrical Code standards. If you are unfamiliar
●
with proper electrical wiring connections, obtain the services of a qualified electrician.
This light fixture is designed to fit standard junction boxes as defined by the National Electrical Code. Please contact a
●
qualified electrician if you have any questions regarding the installation.
PREPARATION
Before beginning to assemble or install lighting fixture, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble, install or operate
the fixture.
Estimated Assembly Time: 30 – 60 minutes (Installation time will vary depending on skill level and existing wiring
conditions. Estimated installation time assumes standard wall junction box and supply wiring are already installed).
Tools Required for Assembly (not included): Electrical tape, Phillips screwdriver, slotted screwdriver, wrench or pliers,
silicone caulking adhesive and caulking gun.
Helpful tools (not included): Wire cutters and/or wire strippers, stepladder.
ASSEMBLY INSTRUCTIONS
1. Turn OFF power to work area at main circuit breaker or fuse box. CAUTION: Do not
rely on the wall switch alone to turn off power.
2. Place the cover (HH) onto the top hood (A), then screw the nipple (GG) onto the top
hood (A) going through the center hole of the cover (HH), then screw the finial (FF)
onto the nipple (GG). Install a bulb (not included) to the socket. Do not exceed a
100-watt incandescent light bulb. Attach the cage (B) to the top hood (A) using the
ball nuts (EE).
Hardware Used
Ball nut
EE
Finial
FF
x 2 Nipple
GG
x 1 Cover
HH
3
1
2
FF
x 1
x 1
Lowes.com/portfolio
GG
HH
A
EE
B