Secure The Bath; Complete The Installation - THE BOLD LOOK OF KOHLER K-11344 Guía De Instalación Y Cuidado

x4

7. Secure the Bath

Turn the bath shell upside down on the saw horses.
Make sure all the drain connections are secure.
Position the shroud on the bath so the edges of the shroud rest inside the bath shell.
Secure the shroud to the bath with a screw at each corner. Do not overtighten.
Apply a bead of 100% silicone sealant around the perimeter of the bottom of the shroud.
Make sure that the foot clips are not in the locked position.
Carefully set the bath into position so the posts on the bath frame fit into the four foot clips, and the
drain tailpiece fits into the drain pipe.
Check for solid fit (no rocking) and a 24-1/8" (613 mm) rim corner height to the finished floor.
If necessary, lift the bath and adjust the four posts as needed to ensure a distance of 24-1/8" (613
mm) from the finished floor to the top of each bath rim corner. Adjust the bath levelers as needed.
Make sure that the bath levelers and bath feet are tight.
Press down on the bath corners with your hand to make sure that the bath does not move up and
down, or side to side. If the bath moves check that all four posts are inside the foot clips, and check
that the floor is level.
Use a flat-blade screwdriver to push in the four locking plates to lock the bath feet in place.

8. Complete the Installation

Secure the drain tailpiece to the drain pipe.
Install the bath faucet according to the instructions included with the faucet.
Kohler Co.
100% Silicone
Sealant
24-1/8"
(613 mm)
9
x4
x4
Post
x2
Bath
Leveler
1207307-2-C