Introduction; General Information; Directional Reference; Servicing The Engine And Drive Train Components - Scag FREEDOM Z SFZ Manual Del Operador

Section 1

1.1 INTRODUCTION

Your mower was built to the highest standards in the industry.
However, the prolonged life and maximum efficiency of
your mower depends on you following the operating,
maintenance and adjustment instructions in this manual.
If additional information or service is needed, contact your
Scag Power Equipment Dealer.
We encourage you to contact your dealer for repairs. All
Scag dealers are informed of the latest methods to service
this equipment and provide prompt and efficient service in
the field or at their service shop. They carry a full line of
Scag service parts.
THE REPLACEMENT OF ANY PART ON THIS
PRODUCT BY OTHER THAN THE
MANUFACTURER'S AUTHORIZED
REPLACEMENT PART MAY ADVERSELY
AFFECT THE PERFORMANCE, DURABILITY OR
SAFETY OF THIS PRODUCT.
USE OF OTHER THAN ORIGINAL SCAG
REPLACEMENT PARTS WILL VOID THE
WARRANTY.
When ordering parts, always give the model and serial
number of your mower. The serial number plate is located
under the seat as shown in Figure 1-1.
SERIAL NUMBER
PLATE LOCATION
2007 SFZ-SPL
Figure 1-1 Mower Serial Number Plate Location
USE ONLY SCAG APPROVED ATTACHMENTS
AND ACCESSORIES. Scag recommends that all
approved attachments and accesories be installed by an
Authorized Scag Dealer.

GENERAL INFORMATION

1
Attachments and accessories manufactured by companies
other than Scag Power Equipment are not approved for use
on this machine.
Scag approved attachments and accessories:
GC-SFZ (p/n TBA)
Hurricane Mulch (p/n TBA)
Mulch Plate (p/n TBA)
SFZ Hitch (p/n TBA)
SFZ - Lights (p/n TBA)
Freedom Striper (p/n TBA)
GC-4D (p/n 9054)
GC-F4 (p/n 9055)
Blade Buddy (p/n 9212)
WARNING:
For pictorial clarity, some illustrations and figures
in this manual may show shields, guards or plates
open or removed. Under no circumstances should
your mower be operated without these devices in
place.
All information is based upon product information
available at the time of approval for printing. Scag
Power Equipment reserves the right to make changes
at any time without notice and without incurring any
obligation.
1.2 DIRECTION REFERENCE
The "Right" and "Left", "Front" and "Rear" of the machine
are referenced from the operator's right and left when
seated in the normal operating position and facing the
forward travel direction.
1.3 SERVICING THE ENGINE AND DRIVE
TRAIN COMPONENTS
The detail servicing and repair of the engine, hydraulic pumps
and gearboxes are not covered in this manual; only routine
maintenance and general service instructions are provided.
For service of these components during the limited warranty
period, it is important to contact your Scag dealer or find a
local authorized servicing agent of the component
manufacturer. Any unauthorized work done on these
components during the warranty period may void your
warranty.