Wattio MOTION Manual De Usario página 18

The notifications must be activated and deactivated on the mobile app.
RESET
In case the sensor does not connect correctly to the
GATE, it could be necessary to reset the device and
switch it on again.
To reset to the original configuration status, press B2
for about ten seconds until the led indicator flashes
green quickly, ending with a single red flash.
It is recommended to remove the batteries in case
the device will be switched off for a long period of
time.
MAINTENANCE
For changing the batteries, press
the flap on the bottom to open the
device.
Once registered, the alarms
must be created on the web
app, to receive notifications.
An alarm must be created with
its corresponding actions and
notifications in case and to make
it work, the alarm must be
assigned to the corresponding
device.
18