Control With The Help Of Your Rf Remote Control; Freqently Asked Questions - Marmitek IRRF7243 Modo De Empleo

3. press Mute button of remote control.
Note: Using Philips Pronto
When 'house code P' is selected on the Mini Controller all commands of
the Pronto will be changed into an X-10 signal on the electric net. The
house code used is the same as the house code selected in the house code
screen of the Pronto. When pressing the buttons of the Mini Controller
'house code P' will be used.

3.3 Control with the help of your RF remote control

To dim lamps:
press the 'on' button with the number corresponding with the unit code of
the module (1 – 16) you want to dim followed by DIM or BRIGHT.
X-10 IRRF Universal remote control selected for RF use:
1. press the mode button of your remote control reserved for Home
Automation.
2. select the number of the module via the numbers key board (1 – 16).
3. press 'volume' +/- to dim.
Note: When on the Mini Controller 'house code P' is selected regardless of
the house code the commands of the remote control will be changed into a
X – 10 signal on the electric net. The house code used is the same as the
one selected on the remote control. When pressing the buttons of the Mini
Controller 'house code P' will be used.

4. FREQENTLY ASKED QUESTIONS

What is the reason for modules to switch on/off spontaneously?
It is possible that a Marmitek X-10 System is installed at one of your
neighbours using the same HouseCode. To solve this problem try to change
the HouseCode of your system, or have FD10 Phase Coupler/Filter installed
at your incoming mains.
IRRF7243 TM 9