Model with LCD display and temperature control
GENERAL DESCRIPTION
Hair straightener, with heating elements, equipped with ON/OFF switch, operation
temperature selection and LCD display.
1
• Switch the hair straightener off after each use.
1 Heating plate
2 On/Off button
3 Temperature LCD display
4 Temperature increase button
5 Temperature decrease button
6 Power cord
SWITCH-ON
• Connect the power plug 6 to the mains socket in accordance with the safety war-
nings described previously.
• Press the button 2.
Plate 1 takes about 3 seconds to turn on. LCD display 3 will then turn on
and display the temperature.
SELECTING THE TEMPERATURE
The hair straightener is preset to 200°C.
Select the desired temperature by pressing the 4 (increase) and 5 (decrease) buttons.
The graduated bar on the LCD display starts flashing. After reaching the set
temperature, the graduated bar will remain steady
Attention: if you have been using the straightener for a few minutes and you
wish to select a lower temperature, it will take a minute or so to cool down and
reach the new set temperature.
TYPE OF HAIR
Fine or treated hair - Fragile
Normal hair - Easy-to-treat
Thick and heavy hair - Thick
STRAIGHTENING
Use according to the type of hair as described in the table above.
Refer to the „Straightening tips" when you wish to straighten the hair.
Standby mode
For added safety, the straightener will switch-off automatically if it is not used
for 60 minutes even though it is connected to the mains.
SWITCH-OFF
• Press the button 2. The straightener 1 takes about 3 seconds to switch off.
• Do not pull the cord or the appliance to disconnect the power cord 6 from the
mains socket. Place it in a safe place and wait as long as is necessary for the
straightener to cool completely.
• Take care not to wind the power cord around the straightener when storing it.
10
3
2
4
5
.
RECOMMENDED TEMPERATURE
150°C (min) / 180°C (max)
180°C (min) / 200°C (max)
200°C (min) / 230°C (max)
6