Febo Flame F18-I-008-018C Manual Del Usuario página 6

ASSEMBLY INSTRUCTIONS
Note: Do not fully tighten the bolts on the assembly until mantel is completed. Assemble the item as
close to its final location as possible.
1. Attach connecting wood (B) to each side of center
panel (A) using long hex bolt (CC), spring washer
(DD) and flat washer (EE). Tighten with Hex wrench
(FF).
Hardware Used
Long Hex Bolt
CC
DD Spring Washer
EE Flat Washer
FF Hex Wrench
2. Insert wood dowels (AA) into each side of center
panel (A). Line up holes on left middle panel (C) and
right middle panel (D) with wood dowels (AA) and
attach to center panel (A) using long hex bolt (CC),
spring washer (DD) and flat washer (EE). Tighten
with hex wrench (FF).
Hardware Used
AA Wood Dowel
CC Long Hex Bolt
DD Spring Washer
EE Flat Washer
FF Hex Wrench
1
EE
A
x 4
B
x 4
x 4
x 1
2
C
A
x 4
x 4
x 4
x 4
x 1
6
FF
CC
DD
A
AA
DD
D
EE
FF
CC
B
AA