Human Touch Perfect Chair pc600 Manual De Uso Y Cuidado página 5

INSTALL THE CONTROL PANEL AND CONNECT THE JADE HEAT PAD.
1. Feed the transformer plug up through the hole in the chair canvas (Fig.7).
2. Connect the transformer cable to both the control panel cable and the jade heat pad cable (the connections
are color-coded), install the connector cover over the connections, then tuck the cables into the seat canvas (Fig.8).
Transformer plug
Jade heat pad cable
Fig.7
Transformer cable (Red)
Jade heat pad cable (Yellow)
3. Remove the three screws taped to the underside of the left-hand armrest cap.
4. Place the control panel bracket on top of the left-hand armrest core (Fig.9).
Center mounting bracket
between screw holes
Fig.9
humantouch.com
Control panel
Control panel cable
Connector box
Transformer cable
Connector box cover
Connector box
Fig.8
6
5. Place the left-hand armrest cap into position, then secure it using the three screws (Fig.10).
6. Using a Phillips-head screwdriver, remove the screw that secures the glide rail safety tip.
Discard this screw (Fig.11).
7. Place the cable loop into position over the screw hole, place the provided washer over the cable loop,
then secure the assembly using the provided screw (Fig.11).
8. Repeat step 5 to install the right-hand armrest cap.
9. Plug the Jade Heat cord into a wall outlet.
Backrest pad
Armrest cap
Fig.10
SECURE THE BODY PAD.
Smooth the body pad into place, from the footrest
toward the backrest. The pad is automatically
secured using the hook and loop fasteners.
SLIDE THE HEAD SOCK OVER THE
HEADREST FRAME.
Slide the head sock over the headrest frame, as far as
it will go. The padded side of the head sock should
face the back of the chair.
Glide rail safety tip
Fig.11
7
Screw
Washer
Cable loop