Shelter Logic SuperMax 26773 Instrucciones De Ensamble página 4

1. PlOT THE lOCATION
Before building your canopy, choose a flat area and plot your location.
A. With enclosed Spikes (10431), stake out the area for the canopy in the desired
spot. The width (W) of the area should be at least equal to the width of the
canopy (18 FT.) and the length should be at least equal to the length (L) - 20 FT.
B. To be sure the staked area is square, tie a rope diagonally from corner to corner.
C. Measure from where the two ropes intersect each other to all 4 corners. These
measurements (A and B) should be the same. If they are not equal the spikes
need to be adjusted until the width, length and inside measurements are correct.
2. lAY OUT ROOF FRAME
• Assembly is easiest if you lay out the roof parts as shown in the location you intend to erect the shelter.
• Start by assembling the center peak then assemble each side.
• All connections use 2
10045
10162
10161
10047
10162
10161
10047
10162
10161
10045
NOTE:
/
1
inch (# 10017) bolts, EXCEPT where noted (
2
802106 802104 802104
802106 802104 802104
802106 802104 802104
802106 802104 802104
Install all carriage bolts with the nut toward the center of the frame.
10046
802104 802104
10162
10161
802104 802104
10048
10162
10161
802104 802104
10048
10162
10161
802104 802104
10046
Page 4
18 ft. W
A B
) use 2 inch (# 10114) bolts.
10045
802106
10162
10161
802106 10047
10162
10161
802106
10047
10162
10161
802106
10045
05_26773_0G
20 ft. L