Use And Adjustment; Maintenance - Benassi BL200 Libro De Uso Y Mantenimiento

S.p.A.
• The machine starts moving forward by pulling the start lever up to position "b" (Fig.n°7 Ref."B").
The machine will immediately stop by releasing the lever.
• BL250: You can insert the reverse gear by pulling the lever (Fig.n°7 Ref."A").in position "b".
• The best adjustment is when the lever of the forward or of the reverse gear in the position shown in picture 13, at a distance
of about 10 mm from the knob, tightens the belt. Should this not be the case, please proceed with the adjustments
mentioned below.
• It is possible to adjust the tension of the idlers by means of the register screws (Fig.n°8 Ref."A,B" and "C,D"), so that the belts do
not slide when the idlers are tightened.
• The handlebar can be vertically adjusted in two different positions by unscrewing the knob (Fig.n°2 Ref."A") and setting the
screw in the other hole after having turned the handlebar, then locking again the knob.
• The tiller is 50 cm wide, it has got 4 knives (2 pieces on each side) and side protection plates (Fig.n°9).
• The blades of the tiller‐knives should always be directed ahead, towards the front of the machine.
• We recommend to use the tiller with the side plates because they improve the stability of the machine while working.
• For the normal maintenance (spark plugs, air filter, regulations) check the booklet for the engine included.
• The frame is provided with tight ball bearings. The chain for the transmission is lubricated with a normal lithium grease.
Every year you should introduce some grease through the hole on the frame (Fig.n°12 Ref."A").
• Keep the machine and the tillers clean and check regularly, al least once a year, that all the screws and nuts are well tied,
especially the screws of the tiller (always wear protection gloves when working on the tiller).
• BL200‐BL250: In case of breaking or wear of the belt you can replace it after removing the side protection cover fixed to the
frame near the engine shaft by unscrewing the three screws that fix the cover to the support. (Fig.n°10 Ref."A"), now the belt of
the forward gear can be replaced (Fig.n°11 Ref."A").
• BL250: In order to remove the belt of the reverse gear it is necessary to remove the small cover (Fig.n°11 Ref."B") by unscrewing
its screw. Remove the belt from the pulleys, install the new belt and adjust it following the instructions mentioned in the chapter
USE AND ADJUSTMENTS, then replace the cover.
• The pin fixing the bigger pulley to the frame pinion has also got a safety purpose: in case there is a heavy obstacle it will break
avoiding damages to other parts of the machine.
• A broken pin has to be replaced by a similar one by putting the new pin in the hole using a hammer and a ripper. To remove the
cover guard follow the instructions mentioned above.
• For any technical repair especially during the guarantee period, it is recommendable to apply to the specialized workshops of our
dealers.
CAUTION
It is advised not to keep the motor running when the machine is not being used for its specific purpose
20
USE AND ADJUSTMENT
MAINTENANCE
BL200/BL 250