Frontier 5NT1622 901 Manual Del Operador página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

UNPACK THE CARTON
Inspect all items for shipping damage as they are
removed from the shipping containers. If you find any
damage, notify the carrier's claims agent and do not
proceed further until the damage has been inspected
by the agent. Refer also to the "Shipping and
Receiving Instructions" packed with the unit.
Use care when unpacking. Miscellaneous parts are
wrapped separately. Verify that they are removed
from the shipping crate so that they are not discarded
by mistake.
NOTE: Before you install the machine, read the
following assembly procedure completely. Then study
"Getting to Know Your Platform Lift" in this Manual.
Remove the Platform Lift System from the Pallet
To remove the machine from the wood crate base.
1. Remove the crate sides, ends and top. Remove
the plastic bag.
2. Unbolt the shipping straps that hold the Platform
Lift System frame to the crate base.
3. Discard the lag bolts and the shipping straps.
4. Lift the Platform Lift System off the crate base and
set it on the floor.
THE PLATFORM LIFT SYSTEM
WEIGHS 415 LBS [188 KG]. USE
POWER EQUIPMENT TO LIFT.
5. The lifting platform is strapped to the main frame
for shipment. Remove and discard the strap and
lower the platform.
6. The 40 amp fuse on the 12 volt cable has been
removed for shipment. To install the fuse, remove the
Removable Back Panel. The panel has six screws
holding it on, four on top and 2 on the bottom. To
install the fuse, open the fuse holder, push in the fuse
then close the fuse holder. See FIG 1 Next, reinstall
the rear panel.
7. Connect to a charging power source
per instructions on Page 11. Charge the
battery for a minimum of eight hours
*
Optional
before initial use of the Platform Lift.
7
FIG. 1

Publicidad

Tabla de contenido
loading

Tabla de contenido