Uline H-3029 Guia De Inicio Rapido página 2

1. Pump the forks higher than 7" or until the lateral
wheels touch the floor. (See Figure 2)
2. Turn the handle 90° (See Figure 3)
3. Locate the orange locking pin on the back side of
the pump.
For safe operation of the Hand Pallet Truck, please read
all warning signs and instructions here and on the pallet
truck prior to use.
1. Do not operate the pallet truck unless you are familiar
with it and have been trained and authorized to do so.
2. Do not use the truck on sloping ground.
3. Never place any part of your body in the lifting
mechanism or under the forks or load. Do not carry
passengers.
4. We advise that operators should wear gloves and
safety shoes.
Figure 5
PAGE 2 OF 9
MOVING TRUCK LATERALLY
Figure 2
A
Figure 3
4. Pull the pin up and twist 90°. (See Figure 4)
5. Lower the pin and ensure the handle is securely
locked to the support base.
SAFETY
5. Do not handle unstable or loosely stacked loads.
6. Do not overload the truck.
7. Always center loads on the forks, not at the end of the
forks. (See Figure 5)
8. The capacity of the truck assumes an evenly
distributed load with the center of the load being at
the halfway point of the length of the forks.
9. Make sure that length of the forks matches the length
of the pallet load.
10. Lower the forks to lowest height when the truck is not
being used.
Figure 4
Locking
Pin
Support
Base
B
1014 IH-3029