Silk’n Pro Instrucciones De Uso página 14

10. Apply the TREATMENT SURFACE to the skin, making sure the skin is spread evenly and smoothly. As soon as
the TREATMENT SURFACE is in full contact with the skin, the READY INDICATOR LIGHT will start blinking.
11. Press the PULSE BUTTON. The device will first determine the color of your skin. If the color of the skin
is light enough for safe application, the device will flash a pulse of light onto your skin, and the READY
INDICATOR LIGHT will turn off. You will see a bright flash of light and simultaneously hear a subtle pop
sound, which is a normal noise for the device. You will feel a mild sensation of warmth and tingling.
Silk'n Pro™ will immediately recharge for the next pulse.
After 3.5 seconds the READY INDICATOR LIGHT will turn on again.
12. Remove the TREATMENT SURFACE from the treated area of skin.
13. Move the TREATMENT SURFACE to another area of skin. Use the pressure marks the device just made
on your skin to guide you for proper positioning of the next pulse, avoiding both gaps and overlaps between
pulses.
Silk'n Pro™ pulses should be administered in rows, starting at one end of each row and progressing
sequentially towards the other end. This technique allows better control of skin coverage, and helps you
avoid treating the same area more than once or overlapping skin areas.
When applied to the skin, the Silk'n Pro™ TREATMENT SURFACE is designed to create temporary
pressure marks on the treated area. These visible marks can be used for proper positioning of the
next pulse.
Try to avoid overlapping pulses!
Warning: Do not treat the same area of skin more than once per hair removal session!
Treating the same area of skin more than once per session increases the likelihood of
adverse effects.
14. Repeat the process until the entire treatment area is covered.
If your skin blisters or burns, STOP USE IMMEDIATELY!
All manuals and user guides at all-guides.com
13