Ovislink EVO-W311AR Guía Rápida De Instalación página 4

CPU
WLAN
WAN / LAN
1, 2, 3, 4
Back panel
DC IN
WAN port
LAN port
RST/WPS
Antenna Interface
2
03_Evo-W311AR_QIG.indd Sec1:2 03_Evo-W311AR_QIG.indd Sec1:2
Off The Evo-W311AR has a hardware error
Flashing The Evo-W311AR is working properly
Off Wireless function is disabled
Flashing Wireless function is enabled
Off There is no device connected to the corresponding port
On There is a device connected to the corresponding port
There is an active device connected to the corresponding
Flashing
port
Plug in the DC power jack.
Note: Please use the original power adapter to prevent the unsuit-
able power adapter damage to your Evo-W311AR.
WAN port (RJ-45). Connect xDSL Modem / Cable Modem or
Ethernet.
4 RJ-45 ports. PC and hub / switch connect to LAN port through
cable.
Press this button for five seconds, the system will be restored to the
RST
factory default settings.
When your wireless LAN adapter connected with the wireless Evo-
W311AR, press this button in the Evo-W311AR, and press the "WPS"
WPS button in your wireless LAN adapter within two minutes, it will gener-
ate a secret key automatically between your LAN adapter and Evo-
W311AR, on the premise that the LAN adapter with WPS function.
Fixed or detachable omni antenna adjust to different models.
28/06/2011 14:48:02 28/06/2011 14:48:02