English; Hardware Installation; Configuring The Device - Level One WAC-2000 Guía De Instalación Rápida

Reset Button
If you need to restore the AC Controller into factory default, please do following procedure:
Power on AC Controller, use a pin to press and hold the reset button until all LED becomes
quick-flash from slow-flash. Then release the button and wait AC Controller to reboot to its
factory default settings. After that, the default IP address of AC Controller is still 192.168.1.1,
default user name and password are both admin;.
Note:
The reset operation will clear all custom settings on the device, please do it with caution.

English

Hardware Installation

Please follow the steps mentioned below to install the hardware:
1. Connect the Device to the local network.
Connect one end of an Ethernet cable to one of the LAN ports on the Device, and the other end
to a network port on a PC, hub, switch or wireless access point. Repeat this step to connect
more PCs or other network devices to the Device.
2. Power on the Device.
Before you power on the Device, make sure that the power supply is normal and well grounded.
Now, the hardware installation is completed.

Configuring the Device

Note: Please assign your computer a static IP address within the same range as the controller's
IP address (192.168.1.1 by default) and make sure your computer is connected with the
controller.
1. Logging to the Device
Launch a Web browser, enter the Device's LAN IP address (192.168.1.1 by default) in the
(a).
address field, and then press the Enter key. (Figure 2)
(b). Enter the default username of admin in the User Name field and default password of
admin in the Password field, click "OK" to access the controller's Web GUI. (Figure 3)
If the login is successful, the home page appears. (Figure 4)
(c).
-3-