Soba XC510 Manual De Instrucciones página 7

XC510 AIR CONDITIONER/DEHUMIDIFIER INSTRUCTIONS
"ST" (Set Temperature) LED light: The light comes on when the TEMPERATURE
UP or TEMPERATURE DOWN buttons are pressed and the LED display shows the new
thermostat temperature setting.
"RT" (Room Temperature) LED light: Comes on when the current room
temperature is shown.
"LO" LED: The light comes on when the low fan speed is selected.
"HI" LED: The light comes on when the high fan speed is selected.
"AUTO" LED: This comes on when the (preset) AUTO MODE is selected. If the
ambient temperature is higher than 25° C the unit will work in cooling mode. If the
ambient temperature is between 20° C and 25° C, the unit will work in ventilation
mode. If the ambient temperature is below 20° C, the unit will work in heating
mode.
"A/C" LED: This comes on when the cooling function is selected.
"DRY" LED: This comes on when the dehumidifier function is selected.
"HEAT" LED: This comes on when the heat function is selected.
"TIMER" LED: This comes on when the timer function is activated.
"RUN" LED: This comes on when the unit is switched on. This light will flash and the
unit will begin to beep and then shut down when the condensation tank is full and the
unit cannot it run off. The light will continue to flash and the unit will remain off until
the condensation is drained from the unit. Please refer to the "CLEANING THE UNIT"
section in this for further information.
NOTE: This unit has a three-minute compressor delay protection circuit.
Consequently, the compressor may take up to three minutes to start when first
turned on or changing modes.
This product is also equipped with a de-frost function. When using the heating
function at low ambient temperature, the heating might be interrupted briefly to
melt the frost. If this happens, just wait for the heating mode to pick up again. As
the appliance has to heat up, the fan will stop for 15-20 seconds when you switch to
the heating mode.
7