RDI METAL WORKS Excalibur Instrucciones De Instalación página 6

LEVEL & ANGLE BRACKET INSTRUCTIONS
1.
Establish the placement of the bottom
of the level panel based on your desired
rail height. Mark a line on your mounting
surface at this height plus 1 1/8" to
represent the top of the mounting
bracket (Fig. 24).
Make an intersecting mark representing
the desired center line of your installed
rail panel. Set the bracket in place
orienting the notch in the top of the
bracket to the center mark and attach
using 2 fasteners appropriate for the
material to which you are installing the
bracket (Fig. 25).
2.
Mark the post 34 1/8" (34 1/8" for
34" high panels or 40 1/8" for 40"
high panels) from the bottom bracket
attached in Step 1 (Figs. 26 & 27). Make
an intersecting mark representing the
desired center line of your installed
rail panel (this mark is the top of the
bracket). Attach the top bracket as you
did the bottom in step 1.
(Fig. 24)
(Fig. 25)
1.
The level angle bracket is the same
bracket as the stair bracket described
above. Level angle mounting varies
greatly on each installation.
Test fit your rail panels and cut to length
for your specific installation. Follow the
general methods described above to
complete your angle installation (Figs. 28
& 29).
(Fig. 26)
(Fig. 27)
6
(Fig. 28)
(Fig. 29)