Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
1. It is recommended to monthly update the diagnosis
software. Use the instrument password to carry out this
operation.
2. Instrument functions follow exactly the manufacturer
indications, so they allow you to complete the operations
in a simple and safe way.
Functions execution (following the instructions on the
screen) does not interfere on other electronic
components, so it is safe and does not cause problem on
vehicle.
3. Follow the instructions below to connect the instrument to
the vehicle:
a. Connect the serial cable or the Wireless device across
diagnosis module and PC then make sure that
communication settings are correct.
b. Connect the diagnosis cable to diagnosis module.
c. Connect the diagnosis cable to the vehicle
4. Through the section „Vehicle Systems diagnosis„ it is
possible to program and set up vehicle control units
and components so its use requires an accurate
knowledge and experience in repairing.
•
Electrical shock. If voltage to measure is more than 40V please don‟t touch directly
the signal to avoid electrical shock and use insulation material to probe signal.
Particular attention is needed for hybrid or electrical vehicle. Before connecting the
probe check that:
•
Engine is switched off and dashboard is off
•
Your hand is always isolated or other part of your body are carefully electrical
isolated.
•
Logic is switched off
P
a
y
A
t
t
e
n
t
P
a
y
A
t
t
e
n
t
i
o
n
-
D
a
n
g
e
i
o
n
-
D
a
n
g
r
o
u
s
e
r
o
u
s
4
Publicidad
Capítulos
Tabla de contenido
