Cleaning And Maintenance - Predator H25C Manual De Instrucciones

• Place the device on a flat level surface and ensure that the air intake and air outlet are clear of
obstruction.
• Insert the plug into a 230V ~ 50Hz power outlet
• Move the ON/OFF SWITCH at the rear of the unit to the on ( I ) position.
• Press the button on the control panel to turn the heater on.
• Adjust the work mode, press
H25C has 3 working modes:
- L mode (1100 W). Pilot L will remain lit in red.
- M mode (1200 W). Pilot M will remain lit in red.
- H mode (1500 W). Pilot H will remain lit in red.
• Press button to turn on/off oscillation.
• Press button to set up the timer hours as below:
- 1 press,1hour, lamp 1on
- 2 presses, 2 hours, lamp 2 on
- 3 presses, 3 hours, lamp 3 on
- 4 presses, 4 hours, lamp 1 and lamp 3 on
- 5 presses, 5 hours, lamp 2 and lamp 3 on
- 6 presses, 6 hours, lamp1, 2 and lamp 3 on.
• Move the ON/OFF SWITCH at the rear of the unit to the off position (O). Turn the power off and
disconnect the plug from the power outlet when not in use.
• If you do not use the device for a long time, clean it and put it in a box. Store in a dry, ventilated
place.
• To clean the appliance, wait until it is completely cold and disconnect it from the mains socket.
• Use a damp cloth to clean the unit. Never clean it by splashing it with water or inserting it into the
appliance.
• Never clean the appliance with acids, gasoline, benzene...
• Before using the appliance again, check it and make sure that nothing obstructs the air inlets and
outlets.
OPERATION

CLEANING AND MAINTENANCE

4