Setting Up The Ir Extender - Marmitek Digital TV Anywhere Modo De Empleo

SETTING UP THE IR EXTENDER

1. Connect the included IR Extender to the input [4] at the back of
the transmitter.
2. Place this IR emitter near the IR window of the A/V device you
want to operate. Before placing the IR emitter definatly you are
advised to check if the extender works properly. Therefore point
your own remote control at the window on the front of the
receiver and press some of the channel selection buttons. If the
channel does not change, the IR emitter may not be fixed in the
right position. The position is sometimes critical.
Environmental Information for Customers in the European Union
European Directive 2002/96/EC requires that the equipment bearing this symbol
on the product and/or its packaging must not be disposed of with unsorted
municipal waste. The symbol indicates that this product should be disposed of
separately from regular household waste streams. It is your responsibility to
dispose of this and other electric and electronic equipment via designated
collection facilities appointed by the government or local authorities. Correct disposal and
recycling will help prevent potential negative consequences to the environment and human
health. For more detailed information about the disposal of your old equipment, please contact
your local authorities, waste disposal service, or the shop where you purchased the product.
6 © MARMITEK