Valet Take-Over; Car Finder - Clifford 4105X Guia Del Propietario

Valet Take-Over

The Valet Take-Over feature allows the vehicle to remain running after
the key has been removed from the ignition. This feature is useful for
occasions when you wish to exit and lock the vehicle for short periods
of time, but would like to leave the engine running and the climate
controls on.
To perform Valet Take-Over:
1. Before turning off the engine, press and release
control for 1 second.
2. Turn the ignition key to the OFF position. The engine will stay run-
ning until the pre- pro gram med time has elapsed or a shutdown
input is received. (See the previous Remote Start section for a
complete list of shut-down inputs.)
Important: This feature will not work if the brake pedal is being
pressed.

Car Finder

Car finder allows you to locate your vehicle, by having the system flash
the parking lights.
To activate:
1. Press and release the
2. The lights flash 5 times slowly allowing you to locate your ve-
hicle.
and buttons at the same time.
on the remote