Bayco 2134 Instrucciones De Operación

Operating Instructions For
Model 2134 / 2166 Work Light
Rechargeable Floodlight • Spotlight
INS-2134-12
Multiple Patents Pending
CAUTION: DO NOT use in explosive atmospheres, near flammable liquids,
or where explosion proof lamps are required
DO NOT use in the proximity of vehicles or equipment when there is a risk of flammable
liquids coming into contact with the handlamp
CAUTION: For Light Duty Use Only
WARNING: NOT FOR USE ABOVE HAZARDOUS LOCATIONS
Thank you for purchasing this Bayco work light. Save these instructions.
Please read these instructions before using your work light. Be sure to charge the work
light before the first use.
CHARGING
Initial Use
Fully charge the work light before the first use. If the battery is new or has been unused
for several months, several charge and discharge cycles may be needed to reach full
battery capacity. To reach maximum performance, run the light to completely discharge
the battery and then recharge. Each charge cycle will extend the operation time until
maximum capacity is achieved. The charge time for maximum capacity is approximately
8 hours.
Regular Use
Use only the supplied AC or DC charging adapter.
 For best performance, charge the work light when the LED's start to dim.
 Connect the AC power adapter to the light. The red indicator will light.
 The red light indicates the work light is being charged. The red light remains on until
the battery is fully charged. At full charge, the light turns off. The total time to full
charge varies depending on the remaining charge in the battery pack.
 Keep the work light plugged into the charger to maintain a trickle charge.
Model Floodlight • run-time
2134 30 LED • 60 Lumens • 2 hrs
2166 60 LED • 120 L • 4 hrs
SAFETY
CAUTION BRIGHT LED RADIATION: AVOID DIRECT EYE EXPOSURE. The light is a
Class 2 LED product per IEC 60825-1 Edition 1.2.2001.
 Do not use or charge this work light in explosive or hazardous areas.
 Do not attempt to repair or disassemble the work light or the charger power supply.
 Use only the supplied AC or DC charger.
TIPS TO EXTEND BATTERY LIFE
The work light NiMH internal battery pack does not have a memory effect. Charging the
work light often helps extend its useful life.
 A new work light or one that has not been used for a long period of time may not
accept a full charge initially. This is normal and does not indicate a problem. Fully
discharge and then charge the unit several times to condition the battery pack for full
capacity. As the battery pack capacity increases the charge time shortens.
 Charge the unit after each use, whether the work light is fully discharged or not.
 Store the work light at room temperature
OPERATION
The work light has a 2 position rocker switch to activate either the floodlight or spotlight.
The center position turns the light off. The magnetic hook can be placed on the top of the
light or the side.
WARRANTY
PRODUCTS COVERED UNDER THIS LIMITED WARRANTY:
This product is warranted to the original purchaser for 1 year and only covers failures due
to defects in materials or workmanship. If this product is used for rental purposes, the
warranty term is reduced to 90 days from the date of purchase.
Charge
Spotlight • run-time
time
4 LED • 8 Lumens • 16 hrs 8 hrs
6 LED • 16 Lumens • 18 hrs 8 hrs
BAYCO • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • www.baycoproducts.com
NOT COVERED
The warranty does not cover normal wear and tear or cosmetic damage. The Limited
Warranty also does not cover damages which occurred in shipment or failures which are
caused by accidents, misuse, abuse, faulty installation and lightning damage.
Consequential damages, incidental damages or incidental expenses, including damage
to property. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply to you. This
warranty gives you specific legal rights, which may vary from state to state. This warranty
does not apply to certain Bayco professional products that carry a specific warranty
unique to those products.
WARRANTY CLAIMS - USA
Contact Bayco for USA warranty claims. Call 800-233-2155 and Bayco Customer
Service will provide a Return Goods Authorization (RGA) to facilitate rapid warranty
action. After receiving the RGA, send the product (shipping prepaid) to BAYCO • 640 S.
SANDEN BLVD • WYLIE, TEXAS • 75098. Include a dated proof of purchase and a brief
description of the defect with your name, address and phone number. Your product will
either be repaired or replaced at the option of Bayco and returned as soon as practical,
but no later than 45 days after being received by Bayco.
WARRANTY CLAIMS - CANADA
Return the product to the place where purchased with a dated proof of purchase and a
brief description of the defect with your name, address and phone number. Your product
will either be replaced or purchase price refunded.
REQUEST FOR WARRANTY ACTION
If you have any questions about this warranty or any other Bayco product inquiries
contact BAYCO • 640 S. SANDEN BLVD • WYLIE, TEXAS • 75098 or call 800-233-2155