Volume Adjustment; Switching On And Off - Contacta RF-RXU Guía De Instalación Y Usuario

4. Using the RF-RXU

4.1 Volume adjustment

Adjust the volume control initially to a low volume to protect your ears.
The volume increases when you turn the dial in the direction of »5« and it
decreases when you turn the dial in the direction of »0«.

4.2 Switching on and off

Place the receiver on your ears. The receiver switches on automatically when
the speaker arms are expanded. The receiver is switched off automatically
when taking it off.
4.3 Reception
Reception will start as soon as the device is switched on. The blue indicator
LED will blink twice every second during an active connection with a Con-
tacta RF transmitter. The indicator LED will begin to blink if there is no active
connection.
4.3 Connecting to a Contacta RF transmitter
Switch a Contacta RF transmitter (RF-TX1, RF-TRX, RF-TXS, or RF-TXRM) on.
The transmitter should be set to MASTER-priority (except RF-TX1, which is
MASTER by default).
To make sure that the RF-RXU connects to the transmission of the intended
transmitter, the receiver should be in close proximity to this transmitter. Place
the RF-RXU on your ears and use a pointed object to press the internal CON-
NECT-button for 2 seconds. The LED blinks in fast succession and the receiver
will now connect with the transmitter.
When switching the receiver off and on again, the receiver will automatically
connect to the previously connected transmitter, given that its channel group
number has not been changed since then. If the channel group number of the
respective transmitter has changed, the receiver needs to be reconnected by
means of the CONNECT button, as described above.
4.4 Power supply / recharge
The device is equipped with a rechargeable lithium-polymer battery of 3,7 V
/ 280 mAh. Place the RF-RXU in the charging dock of the respective charger
(single charger, charging case RF-RXU-DC10).
6 English