Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Congratulations!
With your purchase you have made a decision
in favor of a quality product. Before using, make
yourself familiar with the product.
Read carefully the following instructions
for use.
Use the product only as described and for the
uses stipulated.
Keep these instructions handy.
When transferring the product to third persons
be sure to also pass along all documents.
Delivery contents
1x Instructions for use
1x Dual cylinder foot pump
2x Adapter for inflatable products (5)
1x Adapter for balls (6)
Technical data
Nominal pressure: 72.5 PSI (5 bar)
Dimensions: 11.6 in x 5.9 in x 3.3 in
(295 mm x 150 mm x 83 mm) (L x W x H)
Date of manufacture (month/year):
03/2017
Appropriate use
This product is suitable for private use for
inflating all current bicycle tires with a Schrader
valve, Dunlop valve and Sclaverand valve, and
for inflating balls, airbeds and similar inflatable
products.
Safety instructions
Risk of injury!
• Because of the considerable pressure and the
risk that this involves, the product is not suitable
for use by children and persons with physical
or mental disabilities.
• Before use, check the product and in particular
the connections each time for damage or
wear.
A defective product may no longer be used
and must be disposed of since it cannot be
repaired.
6
US-EN
• Risk of burns! Because of the friction of the
pump piston and pump cylinder, these may
heat up during lengthy inflation. After use, take
hold of the product only by the footboard.
• After inflating for the 80th time, there must be
a cooling-down period of 2 minutes.
Inflate the product only up to the manufacturer's
stipulated maximum pressure. For bicycle tires
this can usually be found on the tire sidewall.
• When inflating, pay attention to the pressure
indicator on the pump and on the product that
you are inflating. Excess pressure brings the
risk of explosion!
• The pressure must be controlled using a
calibrated measuring device.
Before operating
Caution! The product is spring-loaded
and springs open quickly when opened.
Place the product on the floor.
Press the footboard (1) down with one hand,
and with the other unlock the mounting bracket
(2) (fig. B).
To lock the pump, proceed in reverse order.
Use
The product may only be used on a flat, stable
surface.
There must be no kink in the pump hose (3). To
inflate an object, press the footboard evenly and
not too rapidly.
Press the footboard in the center to avoid tilting.
Note: There is a red mark (9) shaped like an
arrow on the pressure gauge indicator.
Using this red mark you can set the desired
maximum pressure as a visual marker.
To do this turn the pressure gauge housing left or
right (fig. C).
Please make sure that the gauge set serves mere-
ly as a guide and does not influence the actual
inflating itself!
• Risk of crushing
fingers!
Operated by foot
only. Not suitable for
use by hand.
Publicidad
Tabla de contenido
