Interface INWMPUNI001I000
Safety instructions
WARNING
Follow carefully this safety and installation instructions. Improper work may lead to serious harmful for your health and also
may damage seriously the interface and/or the AC indoor unit.
• This interface must be installed by accredited technical personnel (electrician, installer or authorized technical personnel)
and following all the safety instructions.
• Before manipulate the AC indoor unit be sure it is completely disconnected from Mains power.
Device description
Installation instructions
1. Check the IR Universal Controller device location using your Air Conditioner IR remote controller.
Make sure that you can control the AC unit properly with the IR remote controller in that location.
The IR Universal Controller can be installed on a wall mounted position or in a desktop position.
IMPORTANT: Keep in mind that some furniture and materials (carpets, curtains, glass, metal...) may effect on the IR
communication.
2. Unplug the Air conditioner (AC) unit from the power supply line.
3. Power the IR Universal Controller:
a.
With the power supply provided along with the IR Universal Controller (Fig A).
Socket-outlet shall be near the equipment and shall be accessible.
b.
Connected to the 230 V connector of the Air Conditioner Indoor Unit (Fig B).
Check the Air Conditioner service manual for detailed information.
A
4. Plug the AC to the power supply line (or the power supply to mains for the IR Universal Controller).
If powering of the IR Universal Controller has been successful, the IR Universal Controller LED will start blinking
Green and then will change to steady Green.
NOTE: Once installation is done, you can proceed with the Wi-Fi and IR configuration as stated in the corresponding
manuals. More information at www.intesis.com.
Doc.Rev.1.1
© HMS Industrial Networks S.L.U - All rights reserved
This information is subject to change without notice
Power Connection
Installation Manual
5
B
Power Connection
URL
https://www.intesis.com
1 / 2