Eddie Bauer 10632 Instrucciones

CLASSIC WOOD BASSINET INSTRUCTION SHEET
Bassinet Model Numbers:
Dorel Juvenile Group, Inc. is an authorized licensee of Eddie Bauer Licensing Services LLC.
Eddie Bauer® and the Eddie Bauer logos are the registered trademarks of Eddie Bauer Licensing Services LLC.
©2012 Cosco Management, Inc. All Rights Reserved. Todos derechos reservados.
www.djgusa.com (800) 544‐1108 www.ebbaby.com/Distributed by (distribuido por) Dorel Juvenile Group, Inc.,
2525 State Street, Columbus, IN 47201‐7494Dorel Distribu on Canada, 873 Hodge, St‐Laurent, QC H4N 2B1
Part No. 4358-5967 9‐21‐2012
Your bassinet locking feature may not be operating properly if the Lock Rod Spring is missing.
Check to ensure the spring is installed with the following steps.
1
2
1
Lock bassinet
Hold Knob in locked position. Pull Lock Rod away from Knob and release.
2
If the Rod springs back, the Spring is installed, and there is nothing else you need to do.
If the Rod did not spring back, DO NOT use the bassinet. Follow the instructions to install the Spring.
Instructions to Install the Spring
Special Note: Although original instructions state, "DO NOT disassemble," for this one-time
spring installation, your bassinet will continue to work properly.
1. Place bassinet on flat surface with Knob facing up.
Underneath bassinet, locate Lock Rod and Rocking Guide.
Rocking Guide
Lock Rod
10632, 10639, 10832, 10839, 10835, BT021
Back Panel
with Keyhole
2.
3.
4.
5. Re-Install Lock Rod
Hold Rod with Red Dot side facing up. Insert opposite end of Rod into Keyhole on
A
Back Panel.
B
Insert Tab at Red Dot end of Rod into Rocking Guide.
C
Insert Rod into back of Knob. Place Front Panel over Rod end.
A
Key Hole in
Back Panel
6.
With the hex key (Allen wrench), remove four bolts.
Raise Front Panel until it separates from Side Boards.
Remove Rod and set aside.
Insert Spring into Keyhole opening on Back Panel.
Back Panel with Keyhole
B
C
Rocking Guide
Line up bolts with threaded holes in Side Boards. Tighten bolts with
hex key (Allen wrench) on Front panel (do not over tighten).
Check the function of the Rod as on first page. If it springs back, your
bassinet is ready to use. If not, DO NOT use the bassinet.
Please call us at 1-877-416-0165.
Red Dot
Back of Knob
on Front Panel