M Confort AIR ENGINE Manual De Usuario página 27

After schedule power-on is set, the digital tube will stop flashing and start
timing if there is button operation in 5 seconds or any button except the
power button is pressed down. At this moment, only the schedule time is
displayed, and the ambient temperature isn't displayed. Press the power
button during the schedule setting or timing, the system will start normally,
run according to the current preset function, and the schedule time will not
be memorized.
c) The default working state turns on when the power is turned on for the
first time.
d) Set schedule power on after normal shutdown (power isn't turned off). At
this moment, the working status is the state before shutdown. For example,
if the cooling mode is turned on when the power is turned off last time, the
cooling mode is also turned on when the power is turned on again. (Note:
This timer set before the last shutdown won't be saved.)
e) When the timer/schedule button is pressed, the corresponding function
indicator flashes (1HZ); for example, if high speed and cooling function are
set at the last shutdown, the timer/schedule indicator is always on and the
high speed indicator + cooling indicator flash. After the machine is turned
on, the MCU starts to detect whether there is water in the water tank when
the pump has been running for 5S. If the software detects that the water
shortage protection switch is off (water shortage) for 5S, the water pump
stops working; the buzzer beeps and alarms 10S (software control).
f) When the schedule power on/off button is pressed, the function that will be
turned on after power on will flash at 1HZ, but the user can also switch to
desired working status, e.g. switching from high speed to low speed or
cooling mode; the schedule power off can't be saved or operated (the sched-
uled function flashes at 1HZ if there is no button operation after 3S, or
flashes immediately if any other button is pressed)
The timing error is within ±3%.
1 0