Connections To Be Made - Axxess CHTO-01 Instrucciones De Instalación

Applications
CHRYSLER
300
Aspen
DODGE
Caliber
Charger
Dakota
Durango
Magnum
Ram 1500
Ram 2500/3500
JEEP
Commander
Compass
Grand Cherokee
Patriot
MITSUBISHI
Raider
From the 16-pin harness
2005-2007
• Connect the (2) Red wires to the ignition/accessory wire of the aftermarket radio.
2007
• Connect the Orange/White wire to the illumination wire of the aftermarket radio. If the aftermarket radio
does not have an illumination wire, tape off the Orange/White wire.
2007-2008
• Connect the Blue/White wire to the amp turn on wire of the aftermarket radio.
2006-2007
2005-2007
• Tape up the Brown wire. It will not be used in this application.
2004-2007
2005-2007
For vehicles with built-in navigation (only), make the following connections:
2006-2008
• Connect the Light Green wire to the parking brake wire of the aftermarket navigation radio.
2006-2009
• Connect the Blue/Pink wire to the VSS or speed sense wire of the aftermarket navigation radio.
2006-2007
• Connect the Green/Purple wire to the reverse wire of the aftermarket navigation radio.
2007-2008
2005-2007 Only make the following connections if the vehicle is amplified:
2007-2008
• Connect the White wire to the left front positive speaker output of the aftermarket radio.
• Connect the White/Black wire to the left front negative speaker output of the aftermarket radio.
2006-2007
• Connect the Gray wire to the right front positive speaker output of the aftermarket radio.
• Connect the Gray/Black wire to the right front negative speaker output of the aftermarket radio.
Continued on next page
CHTO-01

Connections to be made

2