Publicidad
Idiomas disponibles
Idiomas disponibles
Cautions and Warnings
Before using the new measuring rod, please make time to read the following safety
instructions:
Follow the operating instructions.
Use the assembly material supplied.
When assembling, ensure that screws are tight and that the rod has been
assembled correctly.
Fold down the measuring headpiece after height has been measured to avoid
risk of injury.
Assembly Instructions
Step
Instruction
1
Remove the screw and bolt at
bottom-back of the height rod.
(This screw was only for preventing
the middle rod from dropping down
during transport.)
2
Position the green base-
mounting flange over the
matching holes on footplate.
3
Insert the bolts through the top
of the flange into the footplate.
Place the washer and nut onto
the bolt on the underside of the
footplate. Using a Phillips
screwdriver, tighten the bolt
securely to the footplate.
4
Slide the base of the height rod
onto the green base-mounting
flange. Insert the 3 screws on
each side of the height rod into
the rod and securely tighten
using a Phillips screwdriver.
P/N UMADULTHR Rev20141016_web
Illustration
2
Publicidad
