Berner BHR150 Manual De Instrucciones página 8

Learning the Receiver Functions
Turning On/Off the Receiver
1. Press the power/audio button to turn on the receiver.
Note: When the receiver is initially turned on, all LEDs and the
audio signal turn on for one second (diagnostic mode).
Note: The on-grade LED flashes once every two seconds to show
that the receiver is on.
2. Press and hold the power/audio button for two seconds to turn off
the receiver.
Note: When the receiver is being turned off, all the LEDs and the
audio signal quickly turn on for one second.
Selecting the Audio Function
The receiver always starts up with the audio mode active.
1. Press the power/audio button repeatedly to turn on/off the
audio function.
Note: If the audio function is on, the receiver beeps quickly when
the receiver is above the laser beam, slowly when below it, and
continuously when centered in the laser beam or on grade.
7