OPERATION _________________________________
Preparation
Caution
Switch off the appliance and disconnect from
█
supply before changing accessories or ap-
proaching parts that move in use.
1
Remove all packaging and stickers materials
and dispose of them according to the applica-
ble legal regulations.
2
Take the entire unit of the motor housing
and place it on a level surface, e.g. on the
kitchen counter.
3
Now set the glass jug
facing down on a level surface.
4
Remove the blade unit
it counterclockwise and lifting it by holding it
from the sides of the unit.
Caution
Do not remove the blade unit by lifting it from
█
the blades.
The blade unit is very sharp! Handle the
█
blade unit with utmost care, especially during
cleaning, in order to avoid injuries.
5
Clean all parts, with the exception of the
motor housing as described in "Cleaning and
Care".
6
Then re-assemble the jug blender in the
reverse order.
7
Put the glass jug
D
Note
Make sure that the notches on the bottom of
█
the glass jug fit those in the motor housing.
8
Cut the food into small pieces before using
the appliance.
16 ENGLISH
H
with the opening
D
carefully by turning
F
on the motor housing
Blending
1
Place the device on an even and dry surface.
The non-slip feet
appliance.
2
Make sure that the power cord is discon-
nected from the power supply and the control
dial
is on "0" before putting food into the
I
glass jug
3
Take the glass jug
by lifting the glass jug
H
open the lid.
4
Now put the ingredients to be blended in the
glass jug
about 2-5 cm long.
Notes
Add water to ensure the jug blender functions
█
smoothly.
Mix 3 units of hard food and 2 units of water
█
in order to have a smooth jug blender experi-
ence. (i.e: 60 gr hard food 40 ml water)
Caution
Do not put or blend hot foods or liquids in the
█
glass jug. If you process soup, make sure that
the liquid temperature does not exceed 40°C.
To process crushed ice, we suggest you to
█
start with three quarters of ice in the jug and
add 15 ml of cold potable water.
Don´t try to crush ice without adding water to
█
.
H
the jug.
Never let the jug blender operate while empty
█
(without food).
Never let the jug blender operate without the
█
glass jug on the motor housing.
5
Close the lid
measuring cup
and is secured.
6
Place the glass jug
housing
H
ensure the stability of the
J
.
D
from the motor housing
D
upwards and
D
. The ingredients should only be
D
. Make sure that the cap/
C
is inside the lid opening
A
upright onto the motor
D
.