Installation And Operation - IKOS 4HEAT Instrucciones De Instalación

INSTALLATION AND OPERATION

To install the module, you must follow the next steps:
1. Remove the right side of the machine (for the model model I2.A02) or left side (for the
model I2.A03). In the case of Mono models it is not necessary to remove the sides.
2. Connect the module to the stove with the cable supplied in the external connection
provided "telephone connection RS232" and switch on the module by connecting it to the
electric current with the supplied charger.
NOTE: Make sure there is a good Wi-Fi network signal in your home.
3. Install the 4HEAT application available for Android and iOS on your mobile phone.
4. Select the desired language and register with an email and a password. NOTE: If you do
not create the account, you will not be able to control the stove from another network.
5. Click on "Add 4HEAT" button and press the "E" button for "Configuration" in the module
(4HEAT).
6. Connect the smartphone to the "Wi-Fi_4HEAT" network. And press "Next". NOTE: In iOS,
go to Settings → Wi-Fi to find the Wi-Fi_4HEAT network. On Android, go to Settings → Wi-
Fi Settings.
7. In the app select the wireless network of your house. Enter the password and press "OK".
8. Set the PIN you want to access the 4HEAT application and a name for the module, for
example: HOUSE. Press "Next".
9. In case the connection is successful, in the module, the LEDs "A", "B" and "C" will remain
fixed.
10. Connect the smartphone to your home network.
11. To finish the setup, press "Continue" and then "OK" in the second alert. After confirmation
close the application completely (even in the background) and open it again.
From now on, you can manage the operation of your stove remotely from your smartphone
through a Wi-Fi network.
EN // 29
INSTALLATION INSTRUCTIONS
EN