Product Maintenance - Fellowes POWERSHRED W-6C Manual De Instrucciones

BASIC SHREDDING OPERATION
Continuous operation:
NOTE: Shredder runs briefly after
each pass to clear entry.
Continuous operation beyond 4
minutes will trigger a 30-minute
cool down period.

PRODUCT MAINTENANCE

OILING SHREDDER
If not oiled, a machine may experience diminished sheet
capacity, intrusive noise when shredding and could ultimately
stop running. To avoid these problems, we recommend you
oil your shredder each time you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
PAPER JAM
1 2
Set to Reverse
(R) for 2-3
seconds
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to
original consumer. If any part is found to be defective during the warranty period, your sole and
exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective
part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product
usage standards, shredder operation using an improper power supply (other than listed on the
label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any
PAPER/CARD
1 2
Set to Off (O) Set to On (I)
and plug in
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to Off (O)
3 4
Set to Off (O)
and unplug
3 4
Feed paper/card When finished
straight into paper shredding set to
entry and release OFF (O)
2 3
* Apply oil Set to Reverse (R) for
across entry 2-3 seconds
6
5
Gently pull uncut Set to Auto-On
paper from paper (I) and resume
entry. Plug in. shredding
additional costs incurred by Fellowes to provide parts or services outside of the country where the
TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable
specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide,
more details or to obtain service under this warranty, please contact us or your dealer.
Shredder doesn't start:
Wait 30 minutes for motor to cool down.
3