Symmons S-244-2-LAM-RP Instrucciones De Instalación Y Mantenimiento página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Step 5 Install stopper and set eye position
Stopper can be removable
or non-removable
determined by position
of eye hole when
inserting pivot rod.
removable
■ Insert stopper
through flange
opening and rotate
to position eye hole.
Removing stopper
When installed in the removable position,
move pivot rod to the up position (lift rod is in the down position
when later installed). Eye hole will slide over end of pivot rod.
Step 6 Attach pivot rod to drain body
■ Remove retaining
nut and outer seat
from pivot cavity.
■ Insert pivot rod into
pivot cavity so pivot
ball is against inner
seat and rod passes
under end of stopper
according to selected
eye hole position.
■ Insert outer seat
over pivot rod with curved end against pivot ball.
■ Fasten pivot rod to drain body with retaining nut
and tighten using your fingers until ball is seated
snug and pivot rod can move around freely.
Step 7 Connect lift rod and adjust linkage
■ Remove plug on rear
of water spout and
insert lift rod.
■ Fasten end of pivot
rod with spring clip
through location
hole in clevis strap
that is best aligned
to enable lift rod also
be fastened to end of
clevis strap when in
the up position and
stopper is in the
closed position.
■ Insert lift rod into
end of clevis strap
and fasten with thumb
screw at location
where stopper can be
easily opened and closed.
If necessary, select another
location hole in clevis strap and re-adjust lift rod.
stopper
ange
non
removable
pivot rod
retaining nut
outer seat
pivot ball
inner seat
pivot cavity
lift rod
thumb
clevis strap
screw
location
holes
spring
clip
pivot rod
Step 8 Attach drain body to drain trap
Step 9 Flush water supply lines
Thoroughly flush the
supply lines to prevent
foreign matter, i.e.
copper chips, sand, etc.
from damaging the
sealing surface inside
control valves.
■ Remove aerator from
end of faucet spout
by rotating counter
clockwise.
■ Turn hot and cold
faucet handles
to full
position and open water supply
ON
valves long enough to flush supply lines thoroughly.
■ Turn faucet
replace aerator, and check for any water leaks.
OFF,
Care of faucet finish
Clean finish area by using mild soap and water or non-abrasive
cleaner and then rinse immediately. A non-abrasive wax may
be used to preserve finish area.
Valve cartridge replacement
Step 1 Remove handle
Remove Phillips head screw
from center of handle.
Step 2 Remove collar
Remove by turning collar
counter clockwise.
Step 3 Remove cartridge
Using a wrench, turn hex nut
on cartridge counter clockwise.
Ensure valve assembly
Note:
doesn't rotate under sink while
turning nut.
Step 4 Insert new cartridge
Insert replacement cartridge
into center of valve and tighten
hex nut using a wrench.
Step 5 Attach faucet handle
■ Ensure cartridge
spindle is rotated to
the
position.
OFF
■ Attach handle located
in the
position as
OFF
shown in illustration.
■ Insert screw into center
of handle and tighten.
Page 3
remove
aerator
screw
handle
collar
spindle
OFF
hot = cw
cold = ccw
cartridge
valve
handles set in
the OFF position

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Allura s-244-2-lam-xxx-rp serieAllura s-244-2-lam-rp

Tabla de contenido