Publicidad
Idiomas disponibles
Idiomas disponibles
RGB Controller
DEGREE OF PROTECTION
Degree of waterlightness
WARNING
BEFORE STARTING THE INSTALLATION OF THIS PRODUCT,
PLEASE READ THE INSTRUCTIONS CAREFULLY AND KEEP
THEM IN A SAFE PLACE.
INSTALLATION MUST BE CARRIED OUT BY QUALIFIED
PERSONNEL.
IMPROPER HANDLING OF THE COMPONENTS OR
THE LUMINAIRE ITSELF COULD DAMAGE THE PROPER
FUNCTIONING
OF
THIS
MANUFACTURER'S WARRANTY.
THE MANUFACTURER'S GUARANTEE IS VOID: IF THE
INSTALLATION IS NOT CARRIED OUT AS INDICATED IN REBT
2002.
1/2
octubre 2019
IP20
PRODUCT,
VOIDING
THE
[GRÁFICOS: Unidades en mm/ GRAPHICS: Units in mm/GRAPHIQUES: Unités en mm/GRÁFICOS: Unidades em mm]
PRECAUTIONS
• Disconnect the power before handling the product
• This product can not be used in water.
RGB SYNC INSTRUCTIONS
• Connect the luminaire according to the scheme.
• Synchronize remote control, controller and RGB lamps.
• Step 1: To synchronize the controller with the remote control, connect
the lamps and the RGB controller and turn on the power. Press the
"on / off" button of the RGB controller for 3 seconds while pressing the
"off" button on the remote control. The RGB controller will beep. Next,
it will emit another long beep. The synchronization between the RGB
controller and the remote control is finished.
• Step (2): Synchronization of the RGB controller with the lamp: Press the
"on / off" button and the "Speed / Bright +" button at the same time
for 3 seconds. All lamps will change color. "Red" "Green" "Blue", then
release the button.
NOTE: The RGB signal is strong enough up to a maximum of 100m of the
controller's cable to the luminaires. Each RGB controller can synchronize
a maximum of 20 luminaires. Ensure that the cable section is sufficient to
withstand the voltage (12V ac), to avoid voltage drops, see connection
diagram.
Caution: Use magnetic transformer (12V ac according to luminaire voltage),
electronic transformers are not applicable in these LED luminaires.
Publicidad
