Routine Maintenance (Cont.)
Drum pulleys and motor pulleys (for the user, cont.)
Roulette murale
Spare Parts
Always use Bona/Künzle & Tasin spare parts.
Failure to use Bona/Künzle & Tasin spare parts, or repairs/adjustments carried out by unauthorized personnel, will invalidate the
guarantee and any resulting liability.
The machine must only be repaired by qualified personnel.
This electric equipment is compliant with the relevant safety legislation. Repairs must be carried out by qualified personnel using
Bona/Künzle & Tasin spare parts, otherwise the user may suffer serious injury.
Emergency Situations (for the user)
PROBLEM
Motor does not start
Insufficient motor speed
The drum speed is not enough
28
Pulleys with sunken grooves cause the belts to slip and the correct power will not be transferred to
the drum/suction pipe.
This situation can easily occur if the machine loses power during operation. They should therefore
be replaced.
CAUSES
No power supply voltage
Insufficient voltage for unstable connections
Faulty thermal switch
Faulty switch
Faulty capacitors
Faulty motor
Excessive cable length or unsuitable
cross section
Unstable connections
Driving belts at a wrong tension
Faulty capacitors
Faulty motor
Excessive cable length or unsuitable
cross section
Unstable connections
Driving belts too tightened
Worn-out bearings
Faulty capacitors
Faulty motor
SOLUTIONS
Check power supply or try on a different job-site
Contact an authorized Bona dealer
Contact an authorized Bona dealer
Contact an authorized Bona dealer
Contact an authorized Bona dealer
Contact an authorized Bona dealer
Use cables of suitable length and cross section
Contact an authorized Bona dealer
Set them at a right tension value
Replace them
Contact an authorized Bona dealer
Use cables of suitable length and cross section
Contact an authorized Bona dealer
Set them at a right tension value
Contact an authorized Bona dealer
Replace them
Contact an authorized Bona dealer
Bona Belt Lite Manual