Innowater PHRX Manual página 3

WARNINGS
The pH function allows you to measure the pH of your pool and dose acid for
correction in an automatic way.
The ORP (RH) function allows you to control the Salt Water Chlorinator
production of chlorine in your pool, in an automatic way.
However, BOTH probes are subject to wear, their measures may deteriorate over
time and they are a delicate component that can easily be damaged.
Likewise, like any other device, the pH and RH measurement systems could
suffer any failure that could cause an incorrect Reading; Therefore, you should
check periodically by manual pH and RH measures, using approved means to
ensure that the parameters are correct.
INNOWATER TRATAMIENTOS INTERGRALES DEL AGUA S.L., declines all
responsibility for material and personal damages caused by an excessive or
insufficient dosage of acid, or the chlorine production of salt water chlorinator,
due to its handling.
ATTENTION! The acid is corrosive and can severely damage eyes and skin.
Wear protective glasses and gloves when handling the pump and acid.
The device must be protected by a ground conductor and a 30 mA differential
Never open the appliance under current tension. Danger due to voltage 230 VAC.
Any manipulation of the device must be carried out by a qualified professional.
Never connect the control cable with a voltage higher than 230 VAC or current
higher than 1 A.
1