Perel SMART1310 Manual Del Usuario página 6

5. Assembly
Fit the included feet to the unit before using the
appliance. These are to be attached to the base of the
heater using the four included self-tapping screws, taking
care to ensure that they are located correctly in the
bottom ends of the side mouldings.
6. Overview
Refer to the illustrations on page 2 of this manual.
Heater
1
2
3
Control Panel
1
2
3
4
5
6
7
8
Remote Control
1
2
3
4
7. Use
Powering the Appliance
• Connect the appliance to the mains and switch it on. The current ambient temperature is
displayed.
• Select the heating mode (750 W/1250 W/2000 W + frost protection).
Setting the Temperature
• Set the desired temperature with the temperature increase/decrease button. The setting
range is 5 °C to 37 °C. The appliance will automatically enter the stand-by mode as soon
as the room temperature reaches the set temperature, and restart heating when the
ambient temperature drops 1 °C below the set temperature.
• In frost protection mode, an appliance in stand-by will automatically switch to the highest
heating mode (2000 W) as soon as the room temperature drops to 5 °C and switch off
when the ambient temperature reaches 9 °C.
V. 01 – 07/06/2021
air outlet
control panel
handle
selected heating level
fan
frost protection
selected temperature unit
fan button
temperature increase
temperature decrease
timer button
on-off
Wi-Fi
temperature increase
heat setting
SMART1310
4
5
6
9
10
11
12
13
14
15
16
5
6
7
6
on-off switch
temperature sensor
air inlet
running time
selected temperature
measured temperature
on-off button
IR eye
Wi-Fi button
heat setting button
Wi-Fi LED
fan
temperature decrease
timer
©Velleman nv